This product has been discontinued and removed from our shelves.
1. All these parameters are measured under the condition that the truck is static on the solid ground and the platform had been regulated to be at level. The luffing ranges in list are measured under the condition of rated load. When measure the load capacity of the 11.62m long boom, we make sure all the expansion boom sections had been retracted.
2. The rated lifting capacity includes the weight of host lifting hook of 550kg and the auxiliary lifting hook of 100kg.
When the auxiliary boom is fully extended, the actual lifting capacity of the host lifting boom should be 2300kg lower than the rated value.
3. If the host lifting hook is at the end of host boom arm, the actual lifting capacity of auxiliary boom should be 550kg lower than the rated value, and actual lifting capacity of every boom section supported by the boom-end single pulley should be 550kg lower than the rated value and limited within 4000kg.
When the auxiliary lifting hook is on the boom-end single pulley, the actual lifting capacity of each section of the host boom will be 100kg lower than the rated value.
4. Under the condition of not using the fifth supporting leg, the truck crane is forbidden to lift any weight within the 120° sector in front of itself. Only after the fifth supporting leg is mounted can the equipment finish the lifting task 360° all around itself.
5. Please make sure the boom length in the list you refer to is longer than your actual boom length, and arrange the lifting task no heavier than the smallest rate lifting capacity suggested by the list for the sake of safety.
6. At the end of the table are the minimum luffing angles under different boom lengths. It will be risky to lower the boom down below these minimum luffing angles.
|Load capacity||Self weight||kg||45700|
|Axle load||Fore shaft||kg||19700|
|Kinetic parameters||Engine||Loaded||Rated power||kW/(r/min)||132/1800|
|Unloaded||Rated power||kW/(r/min)||276/2200 (WEICHAI) /283/1900(Commins)|
|Rated torque||N.m/(r/min)||1460/1200 ~1600(WEICHAI)/1835/1200(Commins)|
|Traveling parameters||Maximum driving speed||km/h||75|
|Minimum turning diameter||m||24|
|Minimum ground clearance||mm||260|
|Maximum climbing capacity||%||33|
|Fuel consumption per 100 km||L||47|
|Performance parameters||Maximum lifting capacity||t||70|
|Minimum rated Luffing range||m||3|
|The platform tail slewing radius||mm||4200|
|Maximum lifting torque||Standard||kN.m||2354.4|
|Supporting leg interval||Longitude||m||6.0|
|Longest (host boom)||m||43.73|
|Longest (host and auxiliary boom)||m||58.89|
|Longest (host boom)||m||44.1|
|Longest ( host and auxiliary boom)||m||59.1|
|Operation parameters||Luffing time||Full luffing||s||52|
|Extension time||Full extension||s||105|
|Maximum slewing speed||r/min||2.0|
|Maximum lifting speed of host boom with single rope (to the third level of height)||m/min||130|
|Auxiliary lifting speed of auxiliary boom with single rope (to the third level of height)||m/min||130|
|All supporting legs are full extended + fifth supporting leg (360° lifting task)
All supporting legs are full extended (120° front lifting task is forbidden)
|Luffing range(m)||Host boom||Host boom + Auxiliary boom
|Host boom + Auxiliary boom
|Boom length (m)||Auxiliary boom installation angle||Auxiliary boom installation angle|
|Minimum luffing angle of host boom||28||30||45||52||54||53||55||55||58|